INFRARED THERMOMETER DT8380 MANUAL FREE
If, however, you get a result that is outside the listed accuracy specification, you should contact the manufacturer.įeel free to contact the ThermoWorks Calibration Laboratory ( any further questions. If the results of your ice bath test are within your unit's manufacturer's listed specification, you are good to go. Infrared thermometers cannot typically be calibrated at home, but they are known for their low drift. If you perform the test correctly, and your infrared thermometer is properly calibrated, it should read within your unit's stated accuracy specification of 32.0☏ (0.0☌). Step 7: Taking extra care to ensure that the "field of view" (the size and shape of surface area being measured) is well inside the sides of the glass or container, press the button on your infrared thermometer to take a measurement. Note: If you hold your infrared thermometer too far from the surface of the ice bath or hold it at an angle, your measurement will include the sides of the glass or container or even the table it is resting on and give you an inaccurate reading. Step 6: Hold your infrared thermometer so that the lens or opening is directly above and perpendicular to the surface of the ice bath. Step 2: Add very cold water until the water reaches about one half inch (1 centimeter) below the top of the ice. To calibrate your infrared thermometer with an ice bath: Step 1: Fill a large glass to the very top with ice (crushed ice is preferred but not required). Step 5: Make sure your infrared thermometer is set to an emissivity setting of 0.95 or 0.97. Calibrating Your Infrared Thermometer with a Properly Made Ice Bath. Step 4: Create a well of open water where no ice is floating or tamp the ice down so there is a layer of open water at the top of the glass. Step 3: Gently stir the ice mixture and let it sit for a minute or two. Note: If the ice floats up off the very bottom of the glass at all, the ice bath is likely warmer than 32.0☏ (0.0☌). Step 1: Fill a large glass to the very top with ice (crushed ice is preferred but not required). To calibrate your infrared thermometer with an ice bath: Calibrating Your Infrared Thermometer with a Properly Made Ice Bath